2010 Ford Explorer Door Lock Making Locking Noise

If you want to reactivate the beep feature.

2010 ford explorer door lock making locking noise.

1998 ford windstar fuse problem dome light stays on etc you most likely have a bad door ajar switch the door panel has to be removed to access it its on the door latch you can unplug them this will take care of the batt drain prob as for the locks it may be a switch problem most ford vehicles will not let you lock the vehicle from the driver s door when it s open to prevent. Most power door locks operate using gears or motors that may. If the door lock actuators fail they will disable the power door lock feature from working. This will require the driver to use the key to lock or unlock the doors and can disable the power door.

Turn the ignition switch to the off position to exit the enable disable mode. The module is buried down in the lower outside corner of the door. Unusual noises coming from inside the door are one of the first symptoms of a potential problem with a power door lock actuator. Power door locks do not function.

The latch and mechanical lock are the same unit. That may lead you to think the door lock actuator linkage is binding. The horn should honk one time. For vehicles with traditional style door lock cylinders and keys a bad power door lock relay will merely disable the power door lock feature.

If the electric motor or the mechanism inside the door lock actuator wears out the door lock may lock or unlock slowly or work sometimes but not all the time. Inside the module there is a track on which two electrical contacts slide along with the actuator and a small rubber bumper stop. Lock the doors and confirm that the horn does not sound. In some cars a door lock actuator becomes noisy and produces a squeaking or buzzing noise when the power door locks are locked or unlocked.

You will be able to open the hatch by sliding the lever sideways. It has a electrical actuator. However vehicles without door lock cylinders will not be able to lock or unlock the doors until power is restored. Press the power door lock lock button once to enter the command.

Listen for the vehicle s horn to chirp one time. Press the power door lock unlock button one time to command the rap module to toggle the autolock relock feature on or off. For vehicles equipped with door lock cylinders the door can still be opened using the key. Press and hold both the lock and unlock buttons on the remote for at least two seconds.

It was caused by a deteriorated rubber stop inside the door lock actuator module. Watch for the hazard lights to flash once. 2000 town and country van back door will not unlock sounds like the lock is seized you will have to remove the panel it s held on with screws and snap plugs remove all the screws and then gently pull the panel off.